Your roofing system should be inspected on a regular basis to check for defects. When this is not done, damage an occur that allows water, allergens, and debris to enter a home. This can pose health risks to household occupants in addition to damaging your belongings. If you have shingles that need to be replaced, follow these steps to start a Roof Repair in Naples FL.
Roof Repair in Naples FL should start with protecting your personal safety. Don’t replace any shingles when it’s raining or foggy. The weather should allow adequate sunlight for you to safely work. Also, wear shoes with a rubber sole to prevent slipping. Use protective gear such as ropes and a helmet. Any ladder should be sturdy and placed on a flat surface.
Start your Roof Repair in Naples FL by lifting the surrounding shingles. This will allow easy removal of the defective shingle. Remove any nails holding the shingle in place with a crowbar or hammer. Carefully slide the old shingle out. Inspect the area for dried roof cement or other sticky material. Clean the area with a scraper.
Next, slide in a new shingle. You may need to round the edges backwards a little to facilitate this placement. Use appropriate galvanized nails to secure the shingle in place. Gently lift the bottom edge of the new shingle and apply a small amount of roof cement. Press the shingle down and hold it in place for a minute or two. Similarly, apply roof cement to the bottom edge of the overlapping shingle and firmly press it into place. This last action provides the roof with a smooth surface to promote water drain-off.
When you are finished, inspect your work. You may have to repair some steps or start over according to the results. Look at the condition of surrounding shingles. It’s advisable to do multiple replacements at one time to lessen your chances of getting hurt. If you have any concerns or problems regarding your Roof Repair in Naples FL, contact a professional like the ones at Roof Design & Sheet Metal LLC.
