If you have plans for a new outside project, such as installing a fence or building a deck, then you will have to dig quite a few holes. However, you can save yourself time and effort by using Augers in Oregon. These are readily available for rent, or purchase if you need it often, and they are easy machines to operate. However, gathering a basic understanding of how they work is essential.
Get to Know Your Auger
There are quite a few size options available to choose from when looking for Augers in Oregon. There are smaller, one-man units, larger two-person machines and even bigger machines that are typically used for larger, industrial projects. Using the auger is a fairly straightforward process. You will start the machine with a pull rope and then use a twist throttle to engage and accelerate the bit.
A Word of Caution
When you are using a power auger, you need to be sure you know where the underground utilities are located. In order to prevent any issues with these lines you should have them marked by the national service ahead of time. Also, contact the proper code enforcement agency in order to determine if you need to acquire a building permit for your project.
Operating the Auger
Be sure to mark the locations where you are going to place the holes and then dig a small hole for each location by hand. When you have this pilot hole, it will help to steady the auger. Be sure to advance the machine slowly as you dig the holes. You should not dig too deep at first since this may cause issues. When you are not using the auger, then you should be sure that you leave the machine off and in one of the holes you have drilled.
When it comes to Augers you need to be informed in order to use it properly. The information here will help you get started and ensure that your project is successful. Taking the time to do the project right will ensure that you get the holes you need for your project.
Read more about augers
